Available Options; Requirements And Compatibility - Nortel BayStack Instant Internet 100-S User Manual

26 Chapter 1 Introduction
• BayStack Instant Internet Software and Documentation Version 7.11 CD
(Part number 206664-D)
For contents, see

Available options

The Instant Internet 100-S unit is shipped with a seven-port autosensing,
autonegotiating 10/100 Ethernet switch on the front of the unit, a full-duplex/
half-duplex autonegotiating 10/100 megabits per second (Mb/s) Ethernet
connection, and one of the following:
• A third Ethernet connection
• Internal single- or dual-analog modem
• Internal ISDN 128K card (with or without NT1) with a POTS connection
• Internal 1-Meg modem

Requirements and compatibility

Instant Internet supports the following Internet connections:
• Dial-up Point-to-Point Protocol (PPP) connection with optional Multilink
Protocol (MP) at up to two times V.90
• ISDN connection using synchronous PPP and optional Multilink Protocol
(MP) at up to 128 kilobits per second (Kb/s)
• Point-to-Point Protocol over Ethernet (PPPoE) connection using the 1-Meg
modem or an external Ethernet device to connect to an access concentrator
209374-A
"Related publications" on page
Note: If your unit does not have an internal analog modem or ISDN
card, disregard all references to dial-up account and dial-up
configuration throughout this manual.
Note: The speed of dial-up connections can vary internationally.
Consult your local distributor for specifications.
21.