Instant Internet Quick Installation - Nortel BayStack Instant Internet 100-S User Manual

Instant Internet quick installation

These steps guide you through the general process of installing your Instant
Internet hardware.
Install your Instant Internet 100-S unit in a ventilated area that is dust free and
away from heat vents, warm air exhaust from other equipment, and direct
sunlight. Avoid proximity to large electric motors or other electromagnetic
equipment. Be sure to choose a location near your router and LAN or WAN hubs
and close to an electrical outlet.
The communications connection is necessary to provide the link between your
Instant Internet unit and your Internet service provider (ISP). To ensure a proper
communications connection, make sure that you have ordered the appropriate
following services:
• Installation from your telco
• Service from your telco
• Internet access service from your ISP
Be sure to review the information in
If you experience problems during installation, unplug all connections, except the
LAN connection, and then restart the Instant Internet unit.
Chapter 3 Instant Internet 100-S hardware installation
Note: Before you begin the installation, make sure that the power
voltage selector switch matches your power voltage (see
voltage selector switch" on page
to normal operation (see
page 52).
Note: Do not apply power to the Instant Internet unit until you have
completed the installation steps.
40) and the DIP switch settings are set
"Switch settings for normal operation" on
"Installation checklist" on page
Setting Up the BayStack Instant Internet 100-S Unit
41
"Setting the
29.