Ricoh IM 550F Field Service Manual page 192

Insert the power cord into the outlet and turn ON the main power.
7.
•
When installing more than one SD card, perform the merge operation.
Enter the SP mode.
8.
Do this step only if you are installing the option on a machine that is already in use (not a new
9.
machine):
•
If the customer wishes to continue using the same hard disk, execute all three SP modes
below.
•
SP5-801-014 (Clear DCS Setting)
•
SP5-832-001 (HDD Formatting (ALL))
•
SP5-832-002 (HDD Formatting (IMH))
•
If the customer wishes to replace the hard disk with a new one, execute SP5-801-014 only.
•
If the customer continues using the same hard disk, the overwriting of the data stored on
the disk before the option is installed cannot be guaranteed. It is highly recommended to
replace the hard disk with a new one.
10. Set SP5-836-001 (Capture Function (0:Off 1:On)) to a value of 0 (Disable).
11. Execute SP5-878-001 (Option Setup: Data Overwrite Security).
If the installation fails, "Installation failed" is displayed when this SP is executed.
12. Print out the System Settings List and make sure that the option was installed successfully.
13. Reconnect the network cable.
14. Execute SP5-990-005 (SP print mode Diagnostic Report).
15. Make sure that ROM number "D3BC5757A" and firmware version "1.02" appear in both of the
following areas on the report (they must match):
•
"ROM Number / Firmware Version" – "HDD Format Option"
•
"Loading Program"
Configuring "Auto Erase Memory" (Performed by the Customer)
Log in as the machine administrator from the operation panel.
1.
Press the [Settings] icon.
2.
Press [Machine Features Settings].
3.
Press [System Settings].
4.
Press the [Administrator Tools] tab.
5.
Press [Auto Erase Memory Setting].
6.
Press [On].
7.
Select the method of overwriting.
8.
If you select [NSA] or [DoD], proceed to Step 11.
If you select [Random Numbers], proceed to Step 9.
Press [Change].
9.
2.Installation
181