Insert the OCR Unit Type M13 SD card in SD Card Slot 1 [A] (upper slot).
5.
Turn ON the main power.
6.
Press [Enter] in SP5-878-004 (Option Setup: OCR Dictionary).
7.
The SD card ID is saved in the NVRAM, and the ID of the MFP is saved on the SD card. The MFP
and SD card are thereby linked.
When "operation complete" is displayed, press [Close].
8.
•
If the installation fails, "Failed" is displayed. Perform the following steps.
•
Check whether it is a used SD card.
•
Turn OFF the main power, and repeat steps 1-5.
Turn OFF/ON the main power.
9.
10. Press [Enter] in SP5-878-004 (Option Setup: OCR Dictionary).
Dictionary data is copied to the HDD.
•
On the first run, SP5-878-004 links the SD card, and on the second run, copies dictionary
data.
11. Turn OFF the main power, and remove the SD card from the SD card slot.
•
Keep the SD card in a safe place. The original SD card is needed in the event of an HDD
malfunction.
12. Reattach the controller cover.
13. Turn ON the main power.
2.Installation
169