2.Installation
•
Administrator login password
If any of these settings are at their factory default values, tell the customer that these settings must
be changed before you do the installation procedure.
Make sure that "Admin. Authentication" is ON.
3.
[Settings] -> [Machine Features Settings] -> [System Settings] -> [Administrator Tools] ->
[Administrator Authentication Management] -> [Admin. Authentication]
If this setting is OFF, tell the customer that this setting must be ON before you do the installation
procedure.
Make sure that "Administrator Tools" is enabled (selected).
4.
[Settings] -> [Machine Features Settings] -> [System Settings] -> [Administrator Tools] ->
[Administrator Authentication Management] -> [Available Settings]
If this setting is disabled (not selected), tell the customer that this setting must be enabled
(selected) before you do the installation procedure.
•
See the operating instructions "Security" for the factory default values.
Seal Check and Removal
The package comes with tamper-proof seals. Before opening it make sure that the seals have not been
peeled off or broken. The seals will leave "VOID" marks on the package once peeled off (even partially)
and will be considered as defective on arrival.
•
Check the seals and make sure they are NOT broken.
Check the box seals [A] on each corner of the box.
1.
•
Make sure that a tape is attached to each corner.
•
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the
components in the box.
If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
2.
178