Vlan, Stg, And Link Aggregation Feature Support; Table 7 Vlan, Stg, And Link Aggregation Support - Nortel 8300 User Manual

To configure port auto recovery on an individual port basis, you must:
•
•
Port auto recovery is disabled on each port by default on the ERS 8300.
For information about configuring port auto recovery, see
auto recovery" (page
For information about SLPP, see
52).
For information about CP-Limit, see
For information about Link Flap Detect, see Nortel Ethernet Routing Switch
8300 Configuration — Platform Operations (NN46200-602).

VLAN, STG, and link aggregation feature support

Table 7 "VLAN, STG, and link aggregation support" (page 55)
the features supported on the Ethernet Routing Switch 8000 Series.
This table is subject to change. See the release notes that came with your
switch to obtain the latest scalability information.
Table 7
VLAN, STG, and link aggregation support
Feature
Number of VLANs
Port-based VLANs
Policy-based VLANs
Protocol-based
Source MAC-based
IEEE 802.1Q tagging
IP routing and VLANs
IPX routing
IPX VLANs
Special VLANs
Default VLAN
Unassigned VLAN
Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device Manager
Copyright © 2005-2007, Nortel Networks
.
Configure a time delay for port auto recovery or use the ERS 8300
default time delay value.
Enable the port auto recovery feature on the required ports.
87).
8348
See footnote
Supported
Supported
Not supported
Supported
Supported
Not supported
Supported
Supported
Supported
Nortel Ethernet Routing Switch 8300
NN46200-510 03.01 Standard
4.0 27 August 2007
VLAN, STG, and link aggregation feature support 55
"Simple Loop Prevention Protocol" (page
"CP-Limit and SMLT IST" (page
8324
1 See footnote
Supported
Supported
Not supported
Supported
Supported
Not supported
Supported
Supported
Supported
"Configuring port
41).
summarizes
8393
1 See footnote 1
Supported
Supported
Not supported
Supported
Supported
Not supported
Supported
Supported
Supported