Figure 17.
Mini-GBIC removal from 2382 Switch
To install a mini-GBIC:
1
1 Insert the mini-GBIC into a mini-GBIC slot on the front panel until it clicks
into place.
2
2 Remove the protective covering(s) from the port connector(s).
3
3 Insert the network cable.
Note.
cable ends in the proper sides (transmit or receive). Otherwise, the link does not
work.
4
Observe the LED next to the mini-GBIC port:
•
If the LED is green, the 1000-Mbps link is operational.
•
If the LED is unlit, the link is not operational. Check the cable and verify that the device at the other
end of the link is operational.
To remove a mini-GBIC:
1
Remove the network cable(s).
2
Insert the protective covering(s) into the port connector(s).
3
Pull the bail latch on the mini-GBIC forward, away from the MX switch, to unlock it from the front panel.
4
Grasping the bail latch, pull the mini-GBIC out of the slot.
Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the two
Installing and connecting a WSS 61
Grasp bail latch and
pull to remove mini-
GBIC.