Figure 14.
GBIC Installation in 2380 Switch
Figure 15.
GBIC Removal from 2380 Switch
To install a GBIC:
1
Insert the GBIC into a GBIC slot on the front panel until it clicks into place.
2
Remove the protective covering(s) from the port connector(s) and set them aside in a safe place
for later use.
3
Insert the network cable.
Note.
cable ends in the proper sides (transmit or receive). Otherwise,the link does not
work.
Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the two
Installing and connecting a WSS 59
GBIC
Squeeze the
lock clips to
release GBIC.