Installing A New Power Supply - Nortel 2382 Configuration Manual

Installing a new power supply

1
If you are replacing a failed power supply and have not already removed it from the WSS, go to
"Replacing a power supply" on page
2
If you are installing a new power supply in an unused slot, loosen the thumbscrew with a #2 Phillips-head
screwdriver and remove the cover plate.
Store the cover plate in a safe place in case you need to use it at another time.
3
Remove the new power supply from its packaging and lift the supply by grasping the front handle with
one hand and supporting the supply from the bottom with the other hand.
4
Insert the power supply into the 2380's slot as shown in
supply is fully seated and flush with the switch's front panel.
Figure 10. Inserting a Power Supply in a 2380
5
Tighten the thumbscrew using a #2 Phillips-head screwdriver.
6
Go to "Powering on a WSS" on page
Nortel WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Installing and connecting a WSS 51
52.
Figure
53.
10, pushing gently but firmly until the