Status Leds; 2360, 2361, 2380 And 2382 Leds - Nortel 2382 Configuration Manual

24 WSS overview
The 2380 and 2382 provide high-bandwidth centralized control of many indirectly connected APs. The
2380 does not have 10/100 Ethernet ports and does not provide PoE. The 2382 has one 10/100 Ethernet
port (port 3), but this port is intended for management purposes only, and does not provide PoE.
Gigabit interface converter (GBIC) slots (2380 only)—A 2380 switch has four ports. Each port has a slot
for a 1000BASE-SX or 1000BASE-LX fiber-optic GBIC, and a built-in 1000BASE-TX copper interface
with an RJ-45 connector. Only one interface, copper or fiber, can be enabled on a port. The GBIC
interface is enabled by default. You can enable the copper interface (and disable the fiber interface) if
needed.
The gigabit Ethernet ports operate at 1000 Mbps only. They do not change speed to match 10-Mbps or
100-Mbps links.
The fiber-optic GBICs have standard SC Duplex connectors and use either single-mode fiber (SMF) for
LX or multimode fiber (MMF) for SX. GBICs are available separately and are not included with the
switch.
The 2382 switch provides high-bandwidth centralized control of many indirectly connected access points.
The 2382 has one 10/100 Ethernet port (port 3), but this port is intended for management purposes only,
and does not provide PoE.
Miniature Gigabit interface converter (mini-GBIC) slots (2382)—A WSS 2382 switch has two slots
allowing insertion of small form-factor pluggable (SFP) 1000BASE-SX or 1000BASE-LX fiber-optic
mini-GBICs to provide gigabit Ethernet interfaces to the network.
The mini-GBICs have standard SC Duplex connectors and use either single-mode fiber (SMF) for LX or
multimode fiber (MMF) for SX. Mini-GBICs are available separately and are not included with the
switch.
The gigabit Ethernet ports operate at 1000 Mbps only. They do not change speed to match 10-Mbps or
100-Mbps links.

Status LEDs

The WSSs have LEDs that indicate port, power, and CPU status.

2360, 2361, 2380 and 2382 LEDs

Table 2 lists the LEDs for models 2360, 2361, 2380, and 2382.
.
Table 2: WSS Status LEDs—2360, 2361, 2380 and 2382
LED
Mgmt
(2380 and 2382 only)
NN47250-301 (320656-E Version 02.01)
Appearance
Bright green, then fade
(repeated)
Note: This LED appearance
is sometimes called
breathing.
Blinking green
Quickly blinking amber
Meaning
WSS is operating normally.
WSS is booting.
WSS was unable to boot completely.