60 Installing and connecting a WSS
4
Observe the upper LED to the right of the GBIC port:
•
If the LED is green, the 1000-Mbps link is operational.
•
If the LED is blinking amber, traffic is active on the 1000-Mbps link.
•
If the LED is unlit, the link is not operational. Check the cable and verify that the device at
the other end of the link is operational.
To remove a GBIC:
1
Remove the network cable(s).
2
Insert the protective covering(s) into the port connector(s).
3
Squeeze the clips on the sides of the GBIC and pull the GBIC out of the slot.
Connecting to a Fiber Gigabit Device (2382)
You must install a miniature gigabit interface converter (mini-GBIC) to connect an 2382 switch to
1000BASE-SX, 1000BASE-LX, or 1000BASE-TX cable.
Figure 16
shows how to install a mini-GBIC.
Figure 16.
Mini-GBIC Installation in 2382 Switch
NN47250-301 (320656-E Version 02.01)
Figure 17
shows how to remove one.
Mini-GBIC