Turn Signal Indicator Lights; High Beam Indicator Light; High Beam Assist Indicator (Green) (If Equipped); High Beam Assist Warning Indicator (Yellow) (If Equipped) - Subaru Outback 2016 Manual

3-34
Instruments and controls/Warning and indicator lights
the gear position indicator.
While the diesel particulate filter warning
indicator appears, the upshift indicator
informs the driver about the best upshift
timing for regeneration of the diesel
particulate filter. Refer to "Diesel particu-
late filter warning indicator (diesel engine
models)" F3-36.
The gear position indicator and upshift
indicator can be activated or deactivated.
Refer to "Gear Position Indicator Settings
(MT models)" F3-49.
NOTE
It is not possible to change the setting
of the gear position indicator/upshift
indicator when the ignition switch is in
the "ON" position. Change the setting
when the ignition switch is in the
"LOCK"/"OFF" or "ACC" position.
! Gear shift indicator (if equipped)
When shifting up is recommended for
good fuel economy, the upshift indicator
blinks. When shifting down is recom-
mended, the downshift indicator blinks.
NOTE
. The gear shift indicator cannot be
deactivated.
. Usually, the gear shift indicator is
guideline for driving more fuel-effi-
ciency and it also may operate to
prevent a possible engine stall at low
engine speed.
. Also, the gear shift indicator oper-
ates to prevent engine damage at high
engine speed.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to "Front turn signal light" F11-52 or
"Rear combination lights" F11-54.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
&
High beam assist indi-
cator (green) (if
equipped)
This indicator appears when the high
beam assist function is activated. For
details about the high beam assist func-
tion, refer to "High beam assist function"
F3-53.
&
High beam assist
warning indicator (yel-
low) (if equipped)
This warning indicator appears when the
high beam assist function malfunctions.
When this warning indicator appears, we
recommend that you have your vehicle
inspected by your SUBARU dealer.
&
Cruise control indica-
tor
This indicator appears when the cruise
control main button is pressed to activate
the cruise control function.
CAUTION
If the malfunction indicator light
(Check Engine light) illuminates,
the cruise control indicator flashes
at the same time. At this time, do not
drive at high speed. We recommend