Cruise Control - Subaru Outback 2016 Manual

3. When the desired mode is displayed,
press and hold the switch (for approxi-
mately 3 seconds) to confirm the setting.
Once the setting is complete, the con-
firmation message will be displayed (for
e x a m p l e , i f y o u s e l e c t T P M S 3 ,
"TPMS3OK" will be displayed).
After the TPMS mode is displayed, the trip
meter will appear again.
NOTE
If no operations are performed while
the TPMS mode selection is activated,
the display will return to the trip meter
after approximately 10 seconds.
Change the TPMS mode according to
the specified pressure shown on the
tire inflation pressure label.
Starting and operating/Cruise control

Cruise control

NOTE
For models with EyeSight system:
Refer to the Owner's Manual supple-
ment for the EyeSight system.
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 30
km/h (20 mph) or more.
WARNING
Do not use the cruise control under
any of the following conditions.
These may cause loss of vehicle
control.
. driving up or down a steep grade
. driving on slippery or winding
roads
. driving in heavy traffic
. towing a trailer
NOTE
. On uphill and downhill slopes, de-
pending on the degree of the slope and
the load of the vehicle, there may be
cases when a constant speed cannot
be guaranteed.
– CONTINUED –
7-45