Lo Position Indicator Light (Dual Range Mt Models); Turn Signal Indicator Lights; High Beam Indicator Light; Cruise Control Indicator Light (If Equipped) - Subaru Forester 2012 Owner's Manual

3-32
Instruments and controls
This indicator shows the position of the
select lever.
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to
"
Automatic transmission"
s07at
&
LO position indicator
light (dual range MT
models)
This light illuminates when Hi-Lo select
lever is set at Lo position.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, any of the turn signal light bulbs
may be burned out. Replace the bulb as
soon as possible. Refer to
F11-55.
bulbs"
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
&
Cruise control indica-
tor light (if equipped)
This light illuminates when the "CRUISE"
main switch is pressed.
NOTE
F7-18.
. If you press the "CRUISE" main
switch button while turning the ignition
switch to "ON", the cruise control
function is deactivated and the cruise
control indicator light flashes. To re-
S03AE32
activate the cruise control function,
turn the ignition switch back to the
"Acc" or "LOCK"/"OFF" position, and
then turn it again to the "ON" position.
. If this indicator light and the mal-
S03AE20
function indicator lamp "
simultaneously during driving, we re-
commend that you have the vehicle
checked by your nearest SUBARU
dealer.
"
&
Replacing
Cruise control set in-
s11be
dicator light (if
equipped)
This light illuminates when vehicle cruising
S03AE21
speed has been set.
&
Headlight indicator
light
S03AE22
This indicator light illuminates when the
light control switch is placed in the "
" " position.
&
Front fog light indicator
light (if equipped)
This indicator light illuminates while the
front fog lights are illuminated.
&
Rear fog light indicator
light (if equipped)
This indicator light illuminates while the
rear fog lights are illuminated.
" flash
&
Preheating indicator
light (diesel engine
models)
The preheating indicator light illuminates
when the ignition switch is turned to the
"ON" position and turns off after the
engine has sufficiently preheated (a few
S03AE23
seconds later).
NOTE
. When the weather is cold outside,
the preheating indicator light remains
illuminated a little longer than usual.
. For models without push-button
S03AE24
" or
S03AE25
S03AE34
S03AE56