Turn Signal Indicator Lights; High Beam Indicator Light; Cruise Control Indicator Light (If Equipped) - Subaru Outback 2011 Owner's Manual

indicator can be activated or deactivated
by performing the following procedure.
1. Turn the ignition switch to the "LOCK"/
"OFF" position.
2. Press the trip knob to show "
" " on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
: " " or " " and " " or "
1
*
be displayed when the ignition switch is
in the "ON" position.
2
* : MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. The initial setting for your vehicle of
the gear position indicator/shift-up in-
dicator has been set for activation
" " at the time of shipment from the
" or
factory.
. It is not possible to change the
setting of the gear position indicator/
shift-up indicator when the ignition
switch is in the "ON" position. Change
the setting when the ignition switch is
in the "LOCK"/"OFF" or "Acc" posi-
tion.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
" cannot
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to "Front turn signal light" F11-61 or
"Rear combination lights" F11-62.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
Instruments and controls
&
Cruise control indica-
tor light (if equipped)
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the "ON" position and turns off after
approximately 3 seconds.
This light illuminates when the "CRUISE"
main switch is pressed.
NOTE
. If you press the main switch button
while turning the ignition switch "ON",
the cruise control function is deacti-
vated and the cruise control indicator
light "CRUISE" flashes. To reactivate
the cruise control function, turn the
ignition switch back to the "Acc" or
"LOCK"/"OFF" position, and then turn
it again to the "ON" position.
. If this indicator light and the mal-
function indicator lamp "
simultaneously during driving, we re-
commend that you have the vehicle
checked by your nearest SUBARU
dealer.
– CONTINUED –
3-37
" flash