Subaru Outback 2016 Manual page 185

located near the clock display. The clock
display will then start to flash for 5
seconds.
3. While the clock display is flashing,
press and hold the "+" button. The clock
format will then change.
4. The clock display will continue to flash
for approximately 3 seconds to inform you
that the clock display has been changed.
If you want to change the clock display
again, press and hold the "+" button while
the clock display is flashing.
& Climate control mode indica-
tors
1) Set temperature indicator (left-hand side)
2) Set temperature indicator (right-hand
side)
3) Maximum air conditioner ON indicator
4) Air conditioner ON indicator
5) FULL AUTO indicator
6) AUTO indicator
7) Airflow mode indicator
8) Fan speed indicator
Instruments and controls/Information display
& Outside temperature indica-
tor
The outside temperature indicator shows
the outside temperature in a range from
−30 to 508C (−22 to 1228F).
The indicator can give a false reading
under any of the following conditions:
. When there is too much sun.
. During idling; while running at low
speeds in a traffic jam; when the engine
is restarted immediately following a shut-
down.
. When the actual outside temperature
falls outside the specified indicator range.
3-39