Accessories For Models Gr2000-1B, Gr2000-2B, And Gr2000-2B; Figure 1-10 Rubber Feet; Figure 1-11 Rack-Mounting Bracket S - Hitachi GR2000-B Series Installation Manual

Table 1-3
19 PRIMARY 1 Green
20 ACCESS 1 Green
21 RESET Switch
Note 1: If you are using a wrong type of a twisted-pair cable, there is a chance that the indicator will be lit even though
the cable is not connected to the remote device. If so, change the twisted-pair cable to the correct type referring
Chapter 3.
1.1.4

Accessories for Models GR2000-1B, GR2000-2B, and GR2000-2B+

(1) Power Cable
Use a power cable of type IEC-320-C13, which is to be supplied by the customer.
(2) Rubber Feet (4 Pieces)
Necessary when setting up the device on a table.

Figure 1-10 Rubber Feet

(3) Rack-Mounting Bracket Type S (2 Pieces)
Figure 1-11 shows a metal bracket used to mount the GR2000-B unit into a
standard 19-inch open rack. The unit is shipped with two of these brackets.

Figure 1-11 Rack-Mounting Bracket S

(4) Rack-Mounting Bracket Type L (2 Pieces)
Figure 1-12 shows a metal bracket used to mount the GR2000-B unit into a
standard 19-inch cabinet rack. The unit is shipped with two of these brackets.
GR2K-GA-0007
Rev. 5.00
GR2000-2B+ Front Panel Indicators and Switches (continued)
Shows that the "MEM
CARD 1" is running as
primary.
Manual reset
ON: Shows that this MC is running as PRIMARY.
OFF: Shows that this MC is running as SECONDARY, or
otherwise MC is not in use.
ON: Shows that the system is currently accessing this
MC (1). DO NOT pull out this MC when being accessed.
OFF Shows that this MC is idle. You may pull out our
replace this MC when this indicator is OFF.
Press to reset the unit.
Component Overview
1-11