Figure 1-7 Gr2000-2B+ Front View - Hitachi GR2000-B Series Installation Manual

Hitachi Gigabit Router GR2000-B Series Installation Guide
Table 1-2
19 PRIMARY Green
1
20 ACCESS 1 Green
21 RESET Switch
Note 1: If you are using a wrong type of a twisted-pair cable, there is a chance that the indicator will be lit. If so, change
the twisted-pair cable to the correct type referring Chapter 3.
1.1.3 GR2000-2B+
The GR2000-2B+ has the following hardware specifications.
Four built-in Ethernet ports 10BASE-T/100BASE-TX,
Two slot for network interface boards, and
Two MC (Memory Card) slots.
Figure 1-7 shows the front view of the GR2000-2B+ with both option slots filled.
Figure 1-8 show the rear view of the GR2000-2B+.
(1) Outer Appearance
Memory Cards
Slot 1
(MEM CARD 1)
Slot 0
(MEM CARD 0)
RS-232C
Connector
(CONSOLE)
10BASE-T/100BASE-TX

Figure 1-7 GR2000-2B+ Front View

1-8
GR2000-2B Front Panel Indicators and Switches (continued)
Shows that the "MEM
CARD 1" is running as
primary.
Manual reset
Built-In Ethernet
3 (LINE 3)
2 (LINE 2)
1 (LINE 1)
0 (LINE 0)
ON: Shows that this MC is running as PRIMARY.
OFF: Shows that this MC is running as SECONDARY, or
otherwise MC is not in use.
ON: Shows that the system is currently accessing this
MC. DO NOT pull out this MC when being accessed.
OFF Shows that this MC is idle. You may pull out our
replace this MC when this indicator is OFF.
Press to reset the unit.
Network Interface Slots
1 (NIF 1)
0 (NIF 0)
GR2K-GA-0007
Rev. 5.00