Loading, Connecting, and Using the Backpack
Configuring a Receiver and Phone System
Configuring a Receiver and Phone System
NOTE
It is recommended that you configure the measurement project before you
load equipment into the backpack.
1. Connect the hardware security key to the parallel port of the pen tablet
2. If you are using a USB serial converter, thread the USB serial converter
3. Load the hardware into the backpack as shown in
•
NOTES
•
4. Set the battery cable switch to the OFF position and connect the battery
Agilent Wireless Solutions
PC, and slide the pen tablet into the pen tablet case.
cable through the left shoulder strap of the backpack. See
USB Serial Converter (86154A, option 36)" on page 26
information.
If you are connecting directly via COM1, thread the RS-232 null modem
cable through the right shoulder strap of the backpack.
Receivers and Phone" on page
Be sure to secure the receiver in place using the strapping system.
When you are using two receivers, be sure to load them with the RF
connectors toward the middle of the pack for best connections. Place one
receiver facing forward, the other facing backward.
cable to the receiver.
"Backpack with Two
14.
"Connecting the
for more
33