Receiver Battery Use and Care
Battery Operation (86154A, option 500)
Battery Operation (86154A, option 500)
Follow these battery operation tips for best results:
•
•
•
•
WARNING
The charger must not be connected to the battery pack when the battery pack is
attached to the receiver. There are no serviceable parts inside. Do not
disassemble.
Battery Charging
A fully-charged battery powers the receiver for four to four and one-half
hours.
CAUTION
Do not use any charger other than the Agilent 86154-60019. (The charger is
marked with the part number.)
1. Remove the battery pack from the backpack.
2. Plug the battery pack into the charger.
3. Connect the AC line cord to the charger and to the AC line.
4. Turn the battery switch to the ON position.
Agilent Wireless Solutions
To enable the battery to operate the receiver, place the battery pack in the
backpack, plug it into the receiver, and turn it on.
To turn on the battery, locate the on/off switch and switch it to ON
(0 = off; 1 = on).
The led, when lighted, indicates that the power is turned on.
When not in use, the battery should be turned off to save the charge.
75