Com Errors - Agilent Technologies E7473A Getting Started Manual

COM Errors

NOTE
Solving Problems and Updating Your System
Troubleshooting Resource Problems and COM Errors
new windows with less than 20% remaining resources in any of the three
categories could cause Windows 95/98 to overrun its resources.
One solution for increasing the potential number of measurements made in a
given project without exceeding Windows 95/98 resources is to configure the
measurement with the associated virtual front panel turned off. You will be
able to record the data but not display it. This can be done in Configuration
mode, under the Display/Logging tab found under the Measurement tab.
The only solution for increasing the number of windows available during a
measurement is to use Windows NT. It does not have the same systems
resource limitations as Windows 95/98.
The following procedure is suggested for locating and eliminating COM
errors when using the Agilent Technologies RF wireless network test system.
To ensure that hardware is configured correctly, it is highly recommended that
you use the automatic configuration wizard for setting up your projects.
Refer to the online help for information.
84 Agilent Wireless Solutions