Solving Problems and Updating Your System
Updating the Firmware
Updating the Firmware
Sometimes a software update (see
"Updating the Software" on page
89) also
requires a firmware update. With the software update installed, when you run
the updated software and select Collection mode, you will be notified if a
firmware update is required. A series of messages will walk you through the
firmware update process. Before you update the firmware, you must first
insert a firmware write enable key (E6450-60007) into the RX LOOP OUT
connector, as shown in
Figure
5-1, then follow the instructions on the screen.
Remember to remove and safely store the firmware write enable key when
you are prompted to do so by the software.
Figure 5-1 Firmware Write Enable Key
90
Agilent Wireless Solutions