Loading, Connecting, and Using the Backpack
Connecting the Hardware
Connecting the Hardware
It is recommended that you read through the
page 18
directions to the configuration instructions for receiver, phone, and
combination systems.
Table 1-1 Hardware Connections
.
If you have this system
Receiver only
Phone only
Receiver and phone
NOTE
Your system can be configured using either Agilent Technologies-supplied or
customer-supplied components.
NOTE
The software must be installed before you connect the hardware. If your
system includes the 86154A, option 030, a pen tablet computer, the software
was factory-installed. If you are using your own computer, use the Agilent
Wireless Solutions CD and follow the instructions in
on page
Agilent Wireless Solutions
before you begin to connect the hardware. Then refer to
See this topic
"Configuring a Receiver-Only System" on page 29
"Configuring a Phone-Only System" on page 31
"Configuring a Receiver and Phone System" on page 33
51.
"Hardware Installation Tips" on
Table 1-1
"Installing the Software"
for
17