Connecting The Usb Serial Converter (86154A, Option 36) - Agilent Technologies E7473A Getting Started Manual

NOTE
Loading, Connecting, and Using the Backpack

Connecting the USB Serial Converter (86154A, option 36)

Connecting the USB Serial Converter (86154A,
option 36)
The USB-to-Serial Converter, EdgePort/4, from Inside Out Networks™ is a
true Plug-and-Play compatible device. It reduces the number of cables exiting
the backpack by multiplexing up to four serial ports onto one USB cable. To
use the device, you connect the serial devices to the converter, then connect
the converter to the computer.
Windows 98 and Windows NT provide USB and Plug-and-Play capability.
These instructions apply to Windows 98 and Windows NT only.
To Connect the USB Serial Converter for Backpack Usage
For Indoor systems, Agilent Technologies pre-installs the software drivers.
You do not need to install or configure software to use the USB serial
converter.
1. Unzip the left shoulder strap pocket.
2. Feed the USB connector up through the strap, out through the top, then
down through the hole in the top of the backpack (see
page 25).
3. Pull the cable into the inside of the backpack, and plug it into the USB
serial converter.
4. Fasten the USB hub into the case (see
5. Switch on the power to the pen tablet and start the software.
26
Figure 1-8 on
Figure 1-1 on page 14).
Agilent Wireless Solutions