Loading, Connecting, and Using the Backpack
Suiting Up to Take Measurements
Figure 1-12 Tightening and loosening the straps
Put On the Backpack
With a loaded backpack, it is recommended that you connect the straps in the
following order (refer to
Figure 1-12 on page 38
for information on tightening
and loosening straps):
1. Loosen all straps and place the pack on your back.
2. Fasten the waist belt and tighten it so that it rests on your hips. The waist
belt should always remain on your hips, even after the harness is adjusted.
38
Agilent Wireless Solutions