Repacking The Fabric Module Slot Filler Panels; Repacking The Chassis; Removing The Chassis From The Rack - H3C S12500G-EF Series Installation Manual

Repacking the fabric module slot filler panels

1. Prepare the original packing materials, including the packing bag, foam cushion, and packing
box, for a fabric module slot filler panel. Make sure these packing materials are clean, dry, and
not damaged.
2. Remove the fabric module slot filler panel. For more information, see "Replacement
procedures."
3. Place the removed fabric module slot filler panel in the packing bag.
4. Place the foam cushion over the packing bag.
5. Place the fabric module slot filler panel and the foam cushion in the packing box, and seal the
box with tape.
6. Perform the same steps to repack the other fabric module slot filler panels.

Repacking the chassis

Removing the chassis from the rack

The device is heavy. Use a mechanical lift to move the device.
To remove the chassis from the rack:
1. Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are
clean, dry, and not damaged.
2. Put the wooden pallet base to a proper place.
3. As shown in callout 1 in
the mounting brackets to the rack.
4. As shown in callout 2 in
chassis outwards along the slide rails. When most part of the chassis is removed from the slide
rails, lift up the chassis by holding the handles at the chassis sides to completely remove the
chassis from the rack.
5. Put the chassis onto the wooden pallet base.
Figure 9-2, use a Phillips screwdriver to loosen the screws that attach
Figure 9-2, cooperate with a minimum of four people to slide the
9-3