Affixing A Label To A Power Cord - H3C S12500G-EF Series Installation Manual

Figure 7-5 Affixed labels
TO :
B0 2 0 3 1 2

Affixing a label to a power cord

Stick the label to the recessed rectangular area on the identification plate. You can stick the label to
either side of the identification plate. Be sure to affix the labels on the same side of the identification
plates.
A cable tie is bundled 2 cm (0.79 in) away from the connector. You can affix the label to other
positions as needed. Figure 7-6 shows how to affix a label when a cable is laid horizontally.
Figure 7-6 Affixing a label
TO:
B03 -48V2
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate must be on
top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make sure
the label is facing out, as shown in Figure 7-7.
7-4