Qsfp28 Port Leds; Switching Fabric Module Leds - H3C S10500X Series Installation Manual

Status
On
Off
NOTE:
The color of the QSFP+ port LED indicates support of the port for 100-GE/40-GE switchover as
follows:
• Yellow—The port supports 100-GE/40-GE switchover.
• Green—The port does not support 100-GE/40-GE switchover.

QSFP28 port LEDs

The service modules provide a LED for each QSFP28 port to indicate their link status and data
receiving/forwarding status.
Table 8-14 QSFP28 port LED description
Status
Flashing
On
Off
NOTE:
The color of the QSFP28 port LED indicates the port speed as follows:
• Green—100 Gbps.
• Yellow—Less than 100 Gbps.

Switching fabric module LEDs

The LSU1FAB08XE0 switching fabric module uses a pair of RUN and ALM LEDs to indicate its
operating
LSUM1FAB10XE0, LSUM1FAB10XEA0, LSUM1FAB10XEC0, and LSUM1FAB16XD0 switching
fabric modules each use a RUN/ALM/OFL LED to indicate their operating status. See
the LED description.
Table 8-15 Switching fabric module LED description (1)
RUN LED status
Flashing (0.5 Hz)
Off
Off
Flashing (0.5 Hz)
On
status. The LSUM1FAB06XEC0,
ALM LED status
Off
Off
On
Flashing (0.25 Hz)
Off or flashing (0.25 Hz)
Description
A link is present, but no data is being received or sent.
No link is present.
Description
The QSFP28 port is receiving or sending data.
A link is present, but no data is being received or sent.
No link is present.
LSUM1FAB06XEB0,
Description
The switching fabric module is operating correctly.
The switching fabric module is not present or is starting up.
The switching fabric module is faulty.
The temperature of the switching fabric module has
exceeded the upper or lower limit.
The switching fabric module is in offline state.
8-6
LSUM1FAB08XEB0,
Table 8-16 for