Installing A Psr2400-12Ahah-B Power Module - H3C S12500G-EF Series Installation Manual

the other, slide the power module along the guide rails into the slot until the latch locks the
power module in place.
Figure 3-19 Removing a filler panel (S12516G-EF)
Figure 3-20 Installing a power module (S12516G-EF)

Installing a PSR2400-12AHAH-B power module

1. Remove the power module slot adapter. As shown by callout 1 in
captive screw.
2. As shown by callout 2 in
while squeezing the opening in the adapter with your fingers.
3. As shown by callout 3 in
pull it rightwards to disengage the left tabs from the chassis.
4. As shown by callout 4 in
5. As shown in
power module handle with one hand and supporting the power module bottom with the other,
insert the power module into the slot until you hear a click.
Figure 3-21, use your thumb to press the power module slot adapter
Figure 3-21, pull the power module slot adapter part way out, and then
Figure 3-21, pull the power module slot adapter out.
Figure 3-22, orient the power module with the latch below the handle. Holding the
3-18
Figure 3-21, loosen the