Repacking the removable components
Repacking power supplies
CAUTION:
Before removing power supplies, switch off the circuit breakers at the input ends of all power cords,
and remove all the power cords to avoid device damage and bodily injury.
To repack power supplies:
1.
Prepare the original packing materials, including the anti-static bag, foam cushion, and packing
box for a power supply. Make sure these packing materials are clean, dry, and not damaged.
2.
Remove the power supply from the chassis.
For more information, see "Replacing a power supply."
3.
Put the removed power supply into the anti-static bag.
4.
Place the foam cushion over the power supply.
5.
Place the power supply and the foam cushion in the packing box, and seal the box with tape.
6.
Perform the same steps to repack the other power supplies.
Repacking the modules
1.
Prepare the original packing materials, including the anti-static shielding bag, foam cushion,
and packing box, for a module. Make sure these packing materials are clean, dry, and not
damaged.
2.
Remove the transceiver modules from the module.
If no transceiver module is installed, skip this step.
For information about how to remove a transceiver module, see "Replacing a transceiver
module."
3.
Remove the module from the chassis slot.
If a filler panel is provided for the module slot, install the filler panel in the slot after you remove
the chassis from the rack. For information about how to remove a module and install a filler
panel, see "Replacing a module."
4.
Put the removed module into the anti-static bag.
For a module that has a protection box, put the removed module first into the protection box and
then put the box into the anti-static bag.
5.
Place the foam cushion over the module.
6.
Put the module and the foam cushion into the box, and seal the box with tape.
7.
Perform the same steps to repack the other modules.
Repacking the fabric module slot filler panels
1.
Prepare the original packing materials, including the packing bag, foam cushion, and packing
box, for a fabric module slot filler panel. Make sure these packing materials are clean, dry, and
not damaged.
2.
Remove the fabric module slot filler panel. For more information, see "Removing a filler panel
from a fabric module slot."
3.
Place the removed fabric module slot filler panel in the packing bag.
4.
Place the foam cushion over the packing bag.
9-2