Switch Fabric Module Naming Conventions; Mpus; Lsem1Supa0/Lsem3Supa0 - H3C S10500X-G Series Hardware Information

Switch fabric module naming conventions

Figure 12 Switch fabric module naming conventions
LS E M1 SF 06 D 0
1 2
Table 13 Switch fabric module naming conventions
No.
1
2
3
4
5
6
7

MPUs

IMPORTANT:
• To verify compatibility of the module with the software release you are using, see the release
notes.
• The USB port on the MPU outs power in accordance with the USB 2.0 standard. Only a USB
2.0-compliant device can be installed in the USB port. A non-compliant USB 2.0 device might not
be recognized.
• Set the same speed and duplex mode for a management Ethernet port and its peer port.
• If the two management ports are connected to one remote switch, you must assign their peer
ports to different VLANs. Login or file transfer will fail if the peer ports are in the same VLAN.
• When using the BootWare menu to upgrade software or BootWare, make sure you use
10/100/1000BASE-T port M0/0/0 for image transfer.

LSEM1SUPA0/LSEM3SUPA0

View
The LSEM1SUPA0 and LSEM3SUPA0 are MPUs available for the S10506X-G, S10506X-G-PoE,
and S10508X-G switches. MPUs are the core component of the system control plane.
Figure 13 LSEM1SUPA0/LSEM3SUPA0 MPU view (LSEM1SUPA0 as an example)
3 4 5 6 7
Description
Product line. LS represents the switch product line.
Product series. E represents the S10500X-G switch series.
Distinguisher.
Module type. SF represents the switch fabric module.
Compatible switch model. 06 represents that the switch fabric module is
compatible with the S10506X-G/S10506X-G-PoE switch.
Switch fabric module type.
Extended attributes.
14