Figure 3-24 Using a releasable cable tie to secure the power cord to the device (S12516G-EF)
(1) Connect the AC power cord connector into the AC
input receptacle of the power module
(3) Use the releasable cable tie to secure the power cord
to the handle of the power module
Installing transceiver modules
CAUTION:
• To prevent particles from entering the ports, keep the dust plugs in the SFP+ if you are not to
install transceiver modules or cables in the ports.
• To prevent particles from entering the ports, install the dust plugs that come with the service
modules in the QSFP28 ports if you are not to install transceiver modules or cables in the ports.
Installing an SFP+/QSFP+/QSFP28 module
CAUTION:
• Read the following instructions before you install an SFP+/QSFP+/QSFP28 module. Failure to
follow these instructions might cause damage to the SFP+/QSFP+/QSFP28 module.
• Do not remove the dust plug from the SFP+/QSFP+/QSFP28 module if you are not to connect an
optical fiber to the module.
• Before you install an SFP+/QSFP+/QSFP28 module, remove the optical fiber (if any) from it.
To install an SFP+/QSFP+/QSFP28 module:
1.
Unpack the module.
Do not touch the golden plating of the module.
2.
Pivot the clasp of the module up (for a module that uses a plastic pull latch, skip this step).
Holding the module, gently push the module into the slot until it has firm contact with the slot, as
shown in
Figure
3-25.
(2) Feed the releasable cable tie through the
power module handle
(4) Fasten the releasable cable tie
3-21