Appendix C Repacking The Device; Removing Cables From The Device; Removing The Power Cords; Removing The Console Cable - H3C S12500G-EF Series Installation Manual

9

Appendix C Repacking the device

This chapter describes how to repack the chassis, power modules, and modules.

Removing cables from the device

Before repacking the device, remove all cables such as the power cords, console cable, twisted pair
cables, optical fibers, and grounding cable from the device.

Removing the power cords

1. Switch off the circuit breakers at the input end of all power cords.
2. Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.
For more information, see "Installing FRUs."
3. Remove power cords.
For an AC power cord, remove the cable tie, and then remove the power cord connector

from the power module.
For a DC power cord, loosen the screws on the power cord connector, and then remove the

connector from the power module.
4. Perform the same step to remove the other power cords.

Removing the console cable

1. Pull the RJ-45 connector of the console cable out from the console port of the device.
2. Pull the DB-9 connector of the console cable out from the serial port of the PC or the terminal.

Removing the grounding cable

Loosen the two screws at the grounding holes (located at the upper right of the power distribution
box on the rear panel and marked with a grounding sign) of the chassis, as shown by callout 2 in
Figure 9-1, and then remove the grounding cable from the chassis.
Figure 9-1 Removing the grounding cable (S12516G-EF)
(1) Grounding sign (2) Remove the grounding cable from the chassis
9-1