Table of Contents
Advertisement
[Sysname-mst-region] region-name example
[Sysname-mst-region] instance 1 vlan 10
[Sysname-mst-region] revision-level 0
# Activate the MST region configuration.
[Sysname-mst-region] active region-configuration
[Sysname-mst-region] quit
# Configure the device as the primary root bridge of instance 1.
[Sysname] stp instance 1 root primary
# Enable MSTP globally.
[Sysname] stp global enable
For more information about these features, see H3C S12500G-EF Switch Series Configuration
Guides.
Verifying the network configuration
To verify the software version and network configuration, execute display commands in any view.
Task
Display the name, model, and system software version of the
device
Display the current configuration of the device
Display the interface status and configuration
Display the IP configuration of Layer 3 interfaces
Display brief information about active routes in the routing table
Display VLAN settings
Display the spanning tree status and statistics
Connecting the device to the network
WARNING!
To avoid injury to your eyes, do not stare at the fiber ports and optical fiber connectors when
connecting optical fibers.
Before you connect the device to the network, verify that all its basic network settings are correct.
Connecting the device to the network through an optical fiber
You can install a transceiver module (see "Installing FRUs") in a fiber port and use an optical fiber to
connect the port to the network. For more information about optical fibers, see H3C S12500G-EF
Switch Series Hardware Information and Specifications.
To connect a fiber port to a peer device through an optical fiber:
1.
Install a transceiver module into the port.
2.
Remove the dust cover of the optical fiber connector, and clean the end of the optical fiber.
Command
display version
display
current-configuration
display interface brief
display ip interface
brief
display ip routing-table
display vlan
display stp brief
4-5
Advertisement
Chapters
Table of Contents
