Repacking The Fabric Module Slot Filler Panels; Repacking The Router Chassis; Removing The Chassis From The Rack - H3C CR19000-16 Installation Manual

Repacking the fabric module slot filler panels

1. Prepare the original packing materials, including the packing bag, foam cushion, and packing
box, for a fabric module slot filler panel. Make sure these packing materials are clean, dry, and
not damaged.
2. Remove the fabric module slot filler panel.
3. Place the removed fabric module slot filler panel in the packing bag.
4. Place the foam cushion over the packing bag.
5. Place the fabric module slot filler panel and the foam cushion in the packing box, and seal the
box with tape.
6. Perform the same steps to repack the other fabric module slot filler panels.

Repacking the router chassis

Removing the chassis from the rack

The router is heavy. Use a mechanical lift to move the router.
To remove the chassis from the rack:
1. Prepare the original packaging materials for the chassis, including the wooden pallet base,
carton, and packing bag. Make sure they are clean, dry, and not damaged.
2. Place the wooden pallet base at a location where you can move the chassis easily.
3. As shown by callout 1 in Figure12-1, use a Phillips screwdriver to loosen the screws that attach
the mounting brackets to the rack.
4. As shown by callout 2 in Figure12-1, use a minimum of four people to slide the chassis out of
the rack along the slide rails. When most part of the chassis is removed from the slide rails, lift
up the chassis by holding the chassis handles to completely remove the chassis from the rack.
5. Put the chassis onto the wooden pallet base.
12-3