Installing A Fabric Module On The S12508G-Ef - H3C S12500G-EF Series Installation Manual

(3) Release the ejector levers by pressing the spring clips when the fabric module is half-way inserted into the
slot
(4) Fully open the ejector levers
(5) Continue to push the fabric module by holding the ejector levers until the brakes on its ejector levers
engage the slot edges
(6) Simultaneously rotate the ejector levers inward
(7) Verify that the spring clips lock the ejector levers in place

Installing a fabric module on the S12508G-EF

1. Place the fabric module on a workbench and remove the protection box from the connector side
of the fabric module. See
2. Release the ejector levers by pressing the spring clips.
3. Orient the fabric module with the lettering on it upward. Holding the fabric module front panel
near the upper ejector lever with one hand and supporting the module bottom with the other,
place the module bottom on the bottom guide rails of the chassis. Align the fabric module with
the target slot, and then insert it into the slot along the guide rails. See callout 1 in
Make sure the ejector levers are fully opened and keep the module parallel to the slot to avoid
touching other components in the chassis.
4. As shown by callout 2 in
ejector levers engage the slot edges. Simultaneously rotate the ejector levers inward until the
spring clips lock the ejector levers in place and the fabric module is completely seated in the
slot.
Figure 3-14 Removing the protection box from the fabric module (S12508G-EF)
(1) Four screws to secure the protection box to the fabric module
(3) Hold the protection box to disengage it from the connector side of the fabric module
Figure 3-14.
Figure 3-15, continue to push the fabric module until the brakes on its
3-12
Figure
(2) Loosen the captive screws
3-15.