Table of Contents
Advertisement
Repacking the modules
1.
Prepare the original packing materials, including the anti-static shielding bag, foam cushion,
and packing box, for a module. Make sure these packing materials are clean, dry, and not
damaged.
2.
Remove the transceiver modules from the module.
If no transceiver module is installed, skip this step.
For information about how to remove a transceiver module, see "Replacing a transceiver
module or network cable."
3.
Remove the module from the chassis slot.
If a filler panel is provided for the module slot, install the filler panel in the slot after you remove
the chassis from the rack. For information about how to remove a module, see "Replacing a
module." For information about how to remove the chassis from the rack, see
chassis from the
4.
Put the removed module into the anti-static bag.
The modules on the switch have protection boxes. Put the removed module into the protection
box, and then put the box into the anti-static bag.
5.
Place the module into the foam cushion.
6.
Put the module and the foam cushion into the box, and seal the box with tape.
7.
Perform the same steps to repack the other modules.
NOTE:
The switch comes with a filler panel in all slots except the fabric module slots.
Repacking the fabric module slot filler panels
1.
Prepare the original packing materials, including the packing bag, foam cushion, and packing
box, for a fabric module slot filler panel. Make sure these packing materials are clean, dry, and
not damaged.
2.
Remove the fabric module slot filler panel. For more information, see "Installing fabric
modules."
3.
Place the removed fabric module slot filler panel in the packing bag.
4.
Place the fabric module slot filler panel in the foam cushion.
5.
Place the fabric module slot filler panel and the foam cushion in the packing box, and seal the
box with tape.
6.
Perform the same steps to repack the other fabric module slot filler panels.
Repacking the switch chassis
Removing the chassis from the rack
The switch is heavy. Use a mechanical lift to move the switch.
To remove the chassis from the rack:
1.
Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are
clean, dry, and not damaged.
2.
Put the wooden pallet base to a proper place.
rack."
C-3
"Removing the
Advertisement
Table of Contents
