Multitech MMH900 User Manual page 93

7 To reconfigure a channel based on your actual channel
requirements, enter commands as described in Chapter 5 or
Appendix D of this manual. To save new parameters, you must again
execute an AT&W command.
Downline Load
8 If you are downline loading remote parameters, your 8-position DIP
switch SW1 must be in the UP (open) position, refer to the 8-position
DIP Switch in the Configuration Chapter (Chapter 3) of this manual.
The other mux in your network must be configured properly and
have its 8-position DIP switch SW1 in the DOWN (closed) position.
You then can execute a Reset command (Z) to send the new
parameters to your remote mux unit. An MMH904/MMH908 unit
cannot down line load parameters to an MM16/MM32 or MMH16/
MMH32 unit.
9 To return to local parameter display and control, execute a Select
Local Parameter command by entering the following:
AT&SL (hit Return)
Status Reporting
10 If you wish to use the status display and auto reporting feature,
execute the Status Reporting command by entering the following:
AT#S0 (hit Return)
The following will be displayed on your system monitor:
ELAPSED TIME
BLOCKS TRANSMITTED
RETRANSMITS
BLOCKS RECEIVED
RECEIVE BLOCK ERRORS :
LINK ALARMS
REMOTE DOWNS
RECEIVE FLOW CONTROL TIME:
AUTOMATIC REPORTING
To select the bps rate and time interval at which the above status
screen will appear, execute a #RBxx and #RTxx commands as
described in Chapter 5 or Appendix D of this manual.
Chapter 5 - Commands
: 00 DAYS 00 HRS
:
:
:
:
:
00 HRS 00 MIN
: OFF 9600
00 MIN.
0
0
0
0
0
0
00 SEC.
BAUD
93