Table 7-1. Troubleshooting Guide
The following symptoms are typical of problems you might encounter:
•
Supervisory Console not communicating with mux command
port
•
Supervisory Console not communicating with command
modem
•
Garbage on Supervisory console screen
•
Composite Link down with CTS, XMT and REMOTE DWN
LEDs ON
•
Composite Link down with CO, CTS, XMT and RCV LEDs
ON and REMOTE DWN LED ON
•
Composite link down with CO CTS and REMOTE DWN
LEDs ON
•
Composite link and all channels down with REMOTE DWN
and all channel RCV LEDs ON
•
Flashing LINK ALARM LED
•
All channel devices not communicating with mux, composite
link up with CO, CTS,XMT and RCV LEDs ON and
REMOTE DWN OFF
•
Some channel devices not communicating with MultiMux
and composite link up
•
Channel device losing data
Note: If you continue to have difficulty after applying the solutions
to these problems (found on pages 123-126), contact
Technical Support for assistance, refer to Chapter 8.
Chapter 6 - Operating Procedures
101