Multitech MMH900 User Manual page 9

Chapter 1 - Introduction & Description
Chapter 3 - Front and Rear Panel Descriptions
Chapter 3 describes the front panel indicators, the switches and jumpers
within the cabinet and the rear panel connections. The front panel
indicators are described in the various groups depending on the
configuration of the MultiMux. Indicator groups are active depending on
how the MultiMux is used. The front panel is the same for all models
and contains some indicators for future enhancements. The back panel
provides all the cable connections for the early released models with the
addition of cable connections for future releases.
Chapter 4 - Installation
Chapter 4 provides the procedures for unpacking, installing and cabling
your MultiMux. After your MultiMux is cabled, an initial power on
procedure is provided for you to display and modify the channel and link
parameters to fit your configuration.
Chapter 5 - Commands
The MultiMux is software-driven and controlled through its command port
and the supervisory console. This chapter describes the AT commands
and the impact each has on your system's operation.
Chapter 6 - Operating Procedures
Chapter 6 provides the operational information for your MultiMux. The
MultiMux operating procedures address the channel and composite link
parameters. The command modem operating procedures address the
command modem access, dialing, and remote access procedures.
Chapter 7 - Troubleshooting Procedures
This chapter is a guide to troubleshooting your MultiMux. It contains a
listing of error conditions, probable causes and suggested fixes or steps
designed to isolate the failing unit in your communications network.
Chapter 8- Service, Warranty and Tech Support
Chapter 8 provides instructions on getting service for the MultiMux at the
factory, a statement of the limited warranty, information about our user
bulletin board service, and space for recording information about your
multiplexer prior to calling Multi-Tech's Technical Support.
9