Multitech MMH900 User Manual page 130

Vo-1 Result Codes Word or Digit
The command modem can display its Result Codes
on your supervisory console. These codes can
appear either in word("verbose") or single digit
("terse") form. For example, if after dialing, no carrier
signal is detected, the result can be displayed either
as NO CARRIER or as the digit 3. The V command
is used to determine which method is used.
Entering ATV0 will cause the command modem to
display the Result Codes as digits, while ATV1 will
display them as words. If you do not select a
method, the factory default setting will cause the
command modem to use the verbose results.
The following shows the terse and verbose result
codes and a description of each code.
Terse Verbose
0 OK
1 CONNECT A carrier signal has been detected 300 bps.
2 RING
3 No Carrier No Carrier signal has been detected, or the
4 ERROR
5 CONNECT A carrier signal has been 1200 detected at
10 Connect
13 DATA
Appendix D - Command Modem Commands
Description
Your command was executed without errors.
A ring signal has been detected from an
incoming call.
carrier signal was lost.
An error is present in your command
sequence, e.g. invalid characters or too
many characters.
1200 bps.
A carrier signal has been detected at 2400
bps.
Command modem connected as data
modem during auto answer.
130