Multitech MMH900 User Manual page 59

The H1 Menu is as follows:
CHANNEL PARAMETER COMMANDS
B BAUD RATE SELECTION
P PARITY SELECTION
C CHANNEL SELECTION
R RESPONSE TIME PRIORITY
DC DEST. CHANNEL SELECTION
SB STOP BIT SELECTION
DN DEST. NODE SELECTION
SN LOCAL SOURCE NODE NUMBER
E LOCAL ECHO
#S CHANNEL STATISTICS
F FLOW CONTROL
&SL SELECT LOCAL PARAMETERS
&F READ IN FACTORY DEFAULTS
&SR SELECT DOWNLINE LOAD PARAMETERS
L LIST PARAMETERS
WL WORD LENGTH SELECTION
The following example will select CHANNEL 1 and set its baud rate to
2400 and the WORD LENGTH to 8 bits:
For HELP on a specific command, enter "ATH" followed by a command
letter.
ATC1B2400WL8 <ENTER>
Chapter 5 - Commands
59