Multitech MMH900 User Manual page 126

&F Load Command Modem Factory Defaults
The Load Command Modem Factory Default &F
Command resets the S-Registers and command
modem commands to thefactory default values.
They are as follows:
S-Registers: S0=0, S1=0, S2=43, S3=13, S4=10,
S5=8, S6=2, S7=30, S8=2, S9=6, S10=14,S11=95,
S12=50, S18=0, S25=5, S26=1, and S28=0.
Commands:
Command
B1
E1
P
Q0
V1
X4
H0-1 Hanging Up, and Bringing thePhone Line Off
Hook
You can make the command modem hang up (go
On Hook), or go Off Hook, with the H command.
Entering ATH1 (upper case) will bring the line Off
Hook just as if you had picked up the telephone
handset. The command modem remains in
command mode.
You can hang up by entering ATH0 or ATH
(remember that the default value is 0 when nothing
is entered). It is not necessary to use the H1
command to bring the line Off Hook when using the
command modem D command to dial, since the
modem will go off hook automatically when you hit
Return at the end of the Dial command.
I Inquiry for Product Code
Some systems or software packages may
automatically check the "identification" of the modem
with which they are communicating, by using the I
Appendix D - Command Modem Commands
Name
Answer Tone:
Echo:
Dialing:
Result Codes: Enabled
Result Codes: Word
Result Code Set/
Call Progress: Dial Tone
Default
Bell
Enabled
Pulse
& Busy
126