Multitech MMH900 User Manual page 125

Appendix D - Command Modem Commands
following it. For example, if you enter ATD5551212
and hit Return, the command modem will dial the
number 555-1212.
Valid dial characters are 0 through 9, A through D, #
, and *. Dial modifiers are: , P R S=x T W ; @ and !.
In pulse dialing, non- digit characters have no
meaning.
The Dial command can also be used in conjunction
with a telephone set for manual dialing. You would
dial the number on your telephone set, and after
hearing the high-pitched answer tone on your
handset, you would enter ATD on your keyboard
and hit Return. You would then hang up the handset.
Unless you have a specific need to dial in this
manner, we recommend you use the first method,
where the telephone number is entered on your
keyboard.
E0-1 Echo Command Mode Characters
If the command modem is connected to a full duplex
terminal or computer, it will be necessary for the
modem to be configured to echo back characters
entered while in the command mode in order for
them to be displayed. The E command is used to
configure the Command mode echo, with ATE0
disabling the echo and ATE1 enabling the echo.
If neither method is selected, the factory default will
cause the modem to echo the command characters.
125