Appendix G; Mmh2834 S-Registers - Multitech MMH900 User Manual

Appendix G

MMH2834 S-Registers

Introduction
This section covers the MMH2834 memory (option) registers called S-
Registers, where certain MMH2834 modem and command mode
configurations are stored. Each S-Register is assigned a number (S0,
S1, S2, etc.). Use the S command to read and/or change the value
stored in an S-Register (ATSr? to read and ATSr= to change S-Register
values).
S0
Number of Rings Until Modem Answers
Unit:
Range:
Default:
Description:
before answering an incoming call. The default value is one ring
(Decimal 1), which means that the modem answers the call immediately
after the first ring. The maximum number of rings that can be configured
is 255. Setting the value to zero (0) disables auto-answer completely.
S6
Wait Time for Dial Tone
Unit:
Range:
Default:
Description:
RETURN key is pressed before executing a dial command. The default
setting is two seconds (Decimal 2).
* Value for International and DOC units
** Value for International units only
***BABT models only
Appendix G - MMH2834 S-Registers
1 ring
0-255
1
S0 defines the number of rings the modem waits
1 second
2-255, 4-255**, 4-7***
2, 4**,4***
S6 sets the time the modem waits after the
145