Command Description; General Commands - Multitech MMH900 User Manual

5.2

Command Description

The following command descriptions explain the effect that executing
each command has on your MultiMux network. Refer to Chapter 6 for
instructions on how to execute the commands.
5.2.1

General Commands

Z
&W
H, H1-H8
Reset
The Reset command will set the operating
parameters of the MultiMux to its most recently
stored values. Executing the Reset command
performs the same function in the logic as turning
power off and then on to the unit.
Store New Parameters
The Store New Parameters command causes the
MultiMux to store new parameters. Prior to
executing the &W command, any changes to
MultiMux parameters are temporary and do not
affect the unit's operation until you execute the &W
command followed by a reset Z command. The &W
command stores the parameters in nonvolatile
memory and will take affect upon reset or powering
the MultiMux off and on.
Help
The Help commands are designed to give you short
explanations on how to use MultiMux commands.
They will be useful if your manual is not handy,
although the explanations are quite short in
comparison to those in the manual. When a Help
command is executed in conjunction with some
other command, the resulting display will explain
options and information for that command. The
General Help command provides information on the
other MultiMux Help commands.
Chapter 5 - Commands
57