Appendix J - Internal Mmh2834 Composite Link Modem Commands - Multitech MMH900 User Manual

Appendix J - Internal MMH2834 Composite Link Modem Commands

Appendix J - Internal MMH2834 Composite Link
Modem Commands
J.1 Introduction
Before the internal MMH2834 composite link modem commands can be
entered, access to the modem has to be activated using the composite link
access (#CLA1) command. When the MMH2834 modem is configured, the
composite link access (#CLA0) command disables access from the
command port to the composite link. The following sections describe the
MMH2834 modem commands.
Table J-1. MMH2834 Command Summary
TYPE COMMAND
MMH2834 Modem
Dial A: or :
(Section J.1.1)
MMH2834 Modem
Modify Dialing
Procedures
(Section J.1.2)
MMH2834 Modem
Memorize Phone
Numbers
MMH2834 Modem
Store Modem
Configurations
and Defaults
(Section J.1.4)
DESCRIPTION
D Dial
Continuous Redial
$D DTR Dialing
N Dial a Stored Number
Pulse/Tone Dialing
P/T
&P Set Pulse Dial Ratios
, Automatic Pauses in dialing
Y Long Space Disconnect
W Wait for New Dial Tone
R Reverse Mode of Operation
! Flash On Hook
$ AT&T "Calling Card" Tones
@ Quiet Answer
Store Phone Numbers
D...N
NN Number Linking
L List Numbers Stored in Memory
Load Factory Defaults
&F
&W Store Configuration & S-Register
Parameters
Z Reset Modem
V Result Code Terse/Verbose
&M Synchronous/Asynchronous Mode
Select
&X Synchronous Transmit Clock Select
159