Internal Mmh2834 Modem Configuration Commands - Multitech MMH900 User Manual

5.2.6 Internal MMH2834 Modem Configuration
Commands
The internal MMH2834 modem configuration commands configure the
composite link for the internal MMH2834 modem. Additional commands
for setting up the modem are provided in Appendix J.
Command Description
$M Internal MMH2834 Modem Sync/Async Mode
(ASYNC/SYNC) The sync or async mode of the MMH2834 modem
is enabled by the $M(ASYNC/SYNC) command.The
$MSYNC command places the MMH2834 modem in
sync mode. The $MASYNC command places the
MMH modem in async mode. The default value is
async mode.
$M(Dial/Leased) Internal MMH2834 ModemDial/Leased
The Dial/Lease Line $M (Dial/Leased) command
selects the type composite link line the MMH2834 is
set for. The MDial command places the MMH2834
modem in a dial mode. The $MLeased command
places the MH2834 modem in lease line mode. The
default is dial-up mode.
$MWire(2/4) Internal MMH2834 Modem2-Wire/4-WireLease
Line
The 2 or 4 Wire Lease Line $MWire (2/4) command
places the MMH2834 modem in 2-wire or 4-wire
mode. The MWire(2)configures the MMH2834
modem for 2-wire lease line operation.The
$MWire(4) configures the MMH2834 modem for 4-
wire lease lineoperation. The default value is 4-wire
lease line operation.
$MTL(1/10) Internal MMH2834 Modem Transmit Level
The Transmit Level $MTL(0/10) command selects
the decibel level for output transmissions. The
closer the transmit level is to zero the greater the
level (strength) of the output signal. This parameter
should only be changed under the direction of
service personnel. The default condition is 0dbm
($MTL(0)).
Chapter 5 - Commands
83