Multitech MMH900 User Manual page 71

&F Load Factory Parameters
The factory default command resets the MultiMux
parameters to their original factory settings. They
are as follows:
Channel Speed:
Word Length:
Stop Bits:
Parity:
Flow Control:
Enq/Ack Control:
Echo:
Pacing:
Pass EIA:
Pass Xon/Xoff:
Response Time Priority:
&SL Select Local Parameters
The Select Local Parameters command lists the
local channel parameters and enables you to update
them. After the execution of this command, all other
commands will act on the local parameter set. An
&W command stores the parameters. When power
is turned on, the local parameter mode is in effect.
&SR Select Downline Load Parameters
The Select Downline Load Parameters command
lists the remote mux channel parameters and
enables you to update them. After execution of this
command, all other commands will act on the
downline parameter set. To send a new set of
parameters to the remote MultiMux unit, 1) the
Downline Load switch (8-position DIP switch SW1)
must be set properly , 2) then executing an ATZ or
powering off your unit sends the parameters to the
remote mux. Execute an &W to store the
parameters.
Chapter 5 - Commands
19200 bps
8 bits
One
None
XON/XOFF
Off
Off
Off
Off
Off
3
71