Phone Number Memory Commands - Multitech MMH900 User Manual

Appendix J - Internal MMH2834 Composite Link Modem Commands
J.1.3 Phone Number Memory Commands
Storing Phone A telephone number and command line of up to sixty
Numbers characters may be stored in the MMH2834's number memory.
As many as ten of these numbers may be stored.
D...N Each number will be given a name, using the codes N0, N1, N2
up to N9. A phone number is stored by entering ATD, then the
number as it would be dialed, along with any P, T, R, ; or comma
characters, and then entering N followed by the number's
"name," which would be any number from 0 through 9, and then
hitting RETURN.
For example, the tone-dialed number 1-612-631-3550 would be
stored as number N3 by entering ATDT16126313550N3 and
RETURN. The number is not dialed with this store command.
After storing a number, check to see that it has been stored
correctly by typing ATL and hitting RETURN.
When phone numbers are stored, the entire command line is
also stored so that you can effectively create a macro for each
number. For example, if you know a particular number needs to
have extended result codes, detect busy or dial tone, error
correction, Xon/Xoff flow control, pacing, and data
compressionenabled,the
ATX4&E1&E5&E13&E15DT16126313550N3. This would store
the entire command at location N3.
Number Linking You may command the MMH2834 to dial another number
automatically if the first number dialed is bysy. This would
NN be useful in a situation where a computer can be accessed
through more than one phone number. This is called "linking". To
link the number in N1 to the number N2, simply enter ATN1N2
and hit RETURN. Several numbers can be linked in the same
command. For example, you could link N1 to N2 to N3 to N4 by
entering ATN1N2N3N4 and RETURN or you could link N1 to N2
and back to N1 and then back to N2 by entering ATN1N2N1N2
and RETURN.
The only limit on the number of numbers that can be linked is the
60 characters allowed in a command line. Number linking can
not be used with blind dialing, since busy signals would not be
detected. You would have to select the Wait-for-Dial tone dialing
method using the X Command in order to use the Number
Linking feature.
Listing Numbers Telephone numbers that you have stored in the MMH2834's
Stored in memory may be listed and displayed with the L command.
Memory It willdisplay all ten stored N numbers in a format like that
command line would be:
167